SF 101 Shape-Flex®   

All Purpose Woven Fusible Interfacing.  Provides crisp support for collars, cuffs, yokes, pockets, facings and other detail areas of a garment. Adds body and permanent stability when used as a backing for needlework and punch embroidery.

For light to medium woven and knit fabrics, including oxford cloth, chambray, gingham, madras, tattersall, pincord, flannel, polyester/cotton blends.

Woven cotton fusible for light to medium weight fabrics. Blouses and Dresses. Oxford Cloth, Chambry, Poplin and Calico.

Washable, dry cleanable. Machine wash warm, machine dry medium, iron at wool/steam setting

100% Cotton - White (or)  Black - 20" Wide

Directions:

STEP 1 - Trim and Steam-Baste

Pin pattern piece to SHAPE-FLEX® following grain-line arrows; cut. Trim seam allowances to 1/8” (3mm)

Place Fusible side of SHAPE-FLEX® to wrong side of upper collar, outer cuff, facing, etc. Pin, then steam-baste along edges with tip of iron. Remove pins.

 STEP 2 - Fuse  

Cover with a DAMP press cloth.

With iron at wool/steam setting, press FIRMLY for full 10 seconds. Repeat, lifting and slightly overlapping iron until all interfacing is fused.

Use steam iron with metal sole plate. Hand-held steamers will not permanently bond interfacing to fabric.

TIPS: Use your damp press cloth as temperature and timing guide. After 10 seconds, press cloth should be dry. If not raise Iron temperature or hold Iron in place a few seconds longer.