Pellon® SHIR-TAILOR® - #950F
 FUSIBLE NONWOVEN INTERFACING

Shirt Collars and Cuffs have a crisp, smooth, neat, professional look
For light to midweight woven and knit shirtings, including oxford cloth, chambray, gingham, madras, tattersail, pincord, flannel, polyester/cotton clends, kettlecloth;

Shir-Tailor has a  lengthwise grain for stability, crosswise stretch for shaping. Computerdot® fusing system bonds permanently, gives professional “dress shirt” results.

No pre-shrinking necessary, ALWAYS PRE-TEST

Washable, dry cleanable, Machine wash warm, Machine dry low, Iron at perma-press setting.

100% Polyester - 20" Wide - White

GENERAL DIRECTIONS

Step 1/Trim and Steam-Baste
1. Pin pattern piece to SHIRTAILOR following grainline arrows; cut. Trim seam allowances to ⅜” (9mm).
2. Place fusible side of SHIRTAILOR to wrong side of upper collar or outer cuff. Pin, then steam-baste along edges with tip of iron. Remove pins. 

Step 2/Fuse
1. Cover with a DAMP press cloth.
2. With iron at medium permapress/steam setting, press FIRMLY for full 15 seconds. Repeat, lifting     and slightly overlapping iron until all interfacing is fused.
3. Use steam iron with metal sole plate. Hand-held steamers will not permanently bond interfacing     to fabric.

TIP: Use your damp press cloth as a temperature and timing guide. After 15 seconds, press cloth should be dry. If not, raise iron temperature or hold iron in place a few seconds longer.